making fairing boards
Page 1 of 1 • Share •
making fairing boards
Here are a couple pictures of the faring boards I made for this project. They take the 4.5" wide paper....
http://www.gulfstreamcomposites.com/category-s/155.htm
They are made with a flexible laminate (about 4mm or 3/16" thick), 36" long. Handles are dowels epoxied on. They are flexible enough to twist a little. the only thing that could make them a little better would be a firm rubber backing, but that is not needed by any means.



http://www.gulfstreamcomposites.com/category-s/155.htm
They are made with a flexible laminate (about 4mm or 3/16" thick), 36" long. Handles are dowels epoxied on. They are flexible enough to twist a little. the only thing that could make them a little better would be a firm rubber backing, but that is not needed by any means.



Admin - Shine- Admin
- Posts : 478
Join date : 2015-03-31

» Mark 3 driver boards
» printed circuit boards and dry transfer images made easily
» Bakuman - a comic about making comics! By comic-makers!
» Bellarmines - when did they stop making them?
» Anyone goood with making things from fiberglass?
» printed circuit boards and dry transfer images made easily
» Bakuman - a comic about making comics! By comic-makers!
» Bellarmines - when did they stop making them?
» Anyone goood with making things from fiberglass?
Permissions in this forum:
You cannot reply to topics in this forum